We make our corsets so the bottom has a band of binding on it. There you have it: Binding at the bottom. Think of all those ‘B’s!
Any and every size, from really tiny to extremely voluptuous. So far, the smallest person we fitted had an 18-inch waist, and the largest had a 72-inch waist. There are no limits.
Most of the time, the edge with the binding points down. If a corset that fit well at the event seems not to fit when you get it home, the most common cause is that you have it upside down! If you are having any fit problems, please contact us.
The boning in your corset molds itself to the curves of your body in time. This is a good thing to a point, because this is what makes the garment comfortable and fully customized. However, if you have a ready-to-wear corset, you may find that some panels bend more than they should, or buckle a bit at the narrowest point. This usually means you have one of our earlier-model corsets (from before we switched to our current boning, which is much stronger). Bring it in to show us, and if we can’t fix it, we’ll replace the boning for free.
It could also be because you curve more than the number of corset panels can accommodate, and each boning channel is being asked to support more of you than it can. If you’re very curvy, we may need to add extra boning for you – just ask!
It happens – you catch the fabric on a ring or a splinter, you pull too sharply on cold fabric, you scorch it on a candle, and so forth. Contact us, and we’ll see if it can be repaired. You’d be surprised at what we can do. If you followed all your care guidelines and it’s been a year or less since you bought your corset, repairs are free – you just need to cover the postage.
If you just need an extra inch or two, we could add a modesty panel under the lacings of most styles.
Sometimes, it is sometimes possible to stitch a small tuck on the side front and side back panels to take in the corset by as much as 2 inches. If you have sensitive skin, this may not be an option, since the tucks can dig sometimes dig in. This is not possible for corsets with straps.
If you’re wearing your corset to a historical event, you’ll probably wear a chemise beneath it, so this won’t be a problem. If you want the corset-only look, consider protecting your corset from body oils and perspiration with a cotton-spandex tube worn underneath. This will also prevent laces from digging into your skin at the gap of back-laced corsets without modesty panels. Just tuck in the visible spandex fabric away under the corset after lacing to make sure it stays out of sight.
Here’s a tip from one of our regulars:
“I used a French Cleaning mix to remove any sweat smells (it works great). Recently, I purchased a product called Soak, meant for delicates and lingerie, and I used it on my corset – and it worked great! I figured I’d send the name in, as it’s very well priced and if anyone else is wondering what they could use to clean their clothing.“
A custom corset costs two to three times an off-the-rack one, mainly because it takes much more time to construct a custom corset. When you order a custom corset, we’ll need to spend lots of time consulting with you and making a pattern from scratch to your specs and measurements. We may even need to go on a fabric shopping expedition. You get to choose your own fabrics, trims, and details, and you can select every aspect of your garment from the height of the neckline to the length to the exact shape you want the corset to give your body. A ready-to-wear corset takes five to eight hours of work for two people. A custom corset, on average, takes twenty or more hours.
The good news: because we make our corsets in so many different body types as well as sizes, it’s pretty unlikely that you’ll need custom work, unless you have medical issues that need special accommodation or particular details you really want.
We can’t guarantee that dry cleaning will be safe because of all the hardware that goes into a corset. Washing the entire corset is not necessary if you wear something between you and the corset. If you spill something on the surface, you can usually spot-clean it by gently dabbing it with a dampened (not wet) soft cloth (don’t try this on a silk or satin surface!).
If you absolutely need to wash it, you could try this: fill your bathtub with several inches of cool but not freezing cold water and add three or four tablespoons of gentle clear (preferably colourless) liquid soap or detergent. Stir until dissolved. Lower the corset into the water, keeping it flat, and immerse all at once. Swirl around in the water and rub any stain very gently with a finger, with a small dab of extra detergent if needed. Drain the water and fill the tub with clean water, and swirl around until rinsed. Take out the corset, lay flat on a large light-coloured towel (so you don’t risk getting dye transferred onto your corset), and roll up tightly. Press evenly to blot excess moisture, and repeat with new towels if needed until you get the corset as dry as you can. Lay the corset on a dry towel and use your blow dryer to thoroughly dry the area around the metal grommets to prevent rusting, being very careful not to scorch the fabric.
When in doubt, contact us for help before cleaning your corset!
That depends on the effect you want. A corset over a very full ball-gown skirt makes your waist look tiny and creates a dramatic, elegant formal dress. The same corset by itself or over a low-necked T-shirt or camisole with leather pants makes great club wear. Worn with a simple pencil skirt or dress pants, it becomes an outfit for a date or an evening out. You can take it to a historical re-enactment event by wearing it over a white chemise and simple gathered skirt, and to a cosplay or anime convention as a “Gothic Lolita” character outfit over lace and tulle petticoats.
One of the best ways to wear a corset for everyday is to put it under a blazer or suit jacket, or to wear it like a vest over a standard collared button-down blouse.
Contrary to popular myth, wearing a corset should never be painful or uncomfortable. A properly fitted corset that follows the contours of your body does NOT hurt, pinch, or dig in anywhere. You should feel like you’re being evenly contained all over. Your back feels supported, your posture becomes perfect, your abdomen is gently held in, and if you’re large-busted, your shoulders should relax as they no longer have to carry the weight of your breasts.
The first time you put on a corset, you may feel short of breath; if that happens, loosen it off in the back! You must NEVER wear a corset that feels uncomfortable. In a short while, your body adjusts, and suddenly, you’ll want to tighten it up. Ten minutes after putting on a well-fitting corset, you should forget you have it on, unless you’re deliberately tight-lacing.
Remember to drink water and eat; your body may not realize you’re hungry due to the constriction of your stomach. Small quantities of food more often works better than one large meal.
That depends. If the material or stitches are showing signs of stress, such as horizontal pull wrinkles or visible stitching at the seams, you are lacing too tightly. Loosen it off a bit or try a larger size.
Our off-the-rack corsets are very sturdy for everyday wear, but are NOT intended for tight-lacing or waist-training. If that’s what you’re after, contact us for information on specially designed tight-lacing corsets (which MUST be custom-fitted to your body for safety).
You lace yourself up the front just the way you do up your shoes. If you forget how, look at the way the back is laced and imitate it. If you have someone to help you, it’s easiest to loosen off the back laces until you can close the front easily, then get another person to re-tighten the back.
If you’re on your own and aren’t flexible enough to reach the back laces, tighten the front as far as you easily can, and wait for five or ten minutes. Fabric is stretchier when warm, so you’ll find it much easier to close the front once you let the corset warm up to body temperature. If you like your corset really tight, you might need to tighten it after five minutes or so, then again after another five minutes, and so forth, until you get it to close all the way.
For more detailed instructions, see our Fitting Your New Corset document.
First and foremost, you need strong, stiff boning (that’s the vertical ribs that keep a corset from scrunching down into the smallest part of your waist). If you can take four inches of a corset’s boning in your hands and bend that length in half, it’s far too weak to support you. Weak boning will kink, poke, and stab you!
Next, you need heavy-duty lining. If the lining fabric is thin, you’ll get pull lines going across your tummy when you pull the corset tight – not attractive! Also, if you tend to get warm easily, make sure the lining material is made out of a breathable natural fibre, preferably cotton.
Finally, make sure the corset comes in different shapes, not just sizes. A good corset maker will have different corsets for people with long or short waists, straight or flared hips, small or large breasts, and varying heights.
It depends on what type you have.
A overbust corset generally should not be worn inside out due to the one-way curvature of the bust.
If you’re not concerned about getting body oils or perspiration on the fashion fabric, or wear due to abrasion, you can sometimes wear an under bust corset inside out! Keep in mind that we can’t always guarantee that the inside of a corset looks cosmetically perfect unless you specifically ordered a reversible corset.
Any size. We fit everyone from the truly tiny to the majestically proportioned. If we don’t have your size in stock (and we probably do), we will make it for you.